Abstract: Most strains of the widespread endosymbiotic bacterium Wolbachia pipientis are benign or behave as reproductive parasites. The pathogenic strain wMelPop is a striking exception, however: it overreplicates in its insect hosts and causes severe life shortening. The mechanism of this pathogenesis is currently unknown. We have sequenced the genomes of three variants of wMelPop and of the closely related nonpathogenic strain wMelCS. We show that the genomes of wMelCS and wMelPop appear to be identical in the nonrepeat regions of the genome and differ detectably only by the triplication of a 19-kb region that is unlikely to be associated with life shortening, demonstrating that dramatic differences in the host phenotype caused by this endosymbiont may be the result of only minor genetic changes. We also compare the genomes of the original wMelPop strain from Drosophila melanogaster and two sequentialderivatives, wMelPop-CLA and wMelPop-PGYP. To develop wMelPop as a novel biocontrol agent, it was first transinfected into and passaged in mosquito cell lines for approximately 3.5 years, generating wMelPop-CLA. This cell line-passaged strain was then transinfected into Aedesaegypti mosquitoes, creating wMelPop-PGYP,which wassequenced after 4yearsin the insecthost. We observe a rapid burst of genomic changes during cell line passaging, but no further mutations were detected after transinfection into mosquitoes, indicating either that host preadaptation had occurred in cell lines, that cell lines are a more selectively permissive environment than animal hosts, or both. Our results provide valuable data on the rates of genomic and phenotypic change in Wolbachia associated with host shifts over short time scales. © The Author(s) 2013. Published by Oxford University Press on behalf of the Society for Molecular Biology and Evolution.

Abstract: The present research deals with helical piles behavior in cohesionless soil through finite element modeling. An approach of modeling of the screw-pile geometry has been proposed through the Finite Element Analysis (FEA) computer program Plaxis. The numerical results are compared with measurements from large scale test and the bearing capacity has been estimated using both cylindrical and individual bearing model. Moreover, different failure criterions have been applied to estimate the ultimate capacity. The effect of spacing ratio (S/Dh) on the screw-pile behavior has been further studied. It has found that results from the model fit the field results. Through the study of the load transfer mechanism, the transition from cylindrical shear to individual plate behavior occurs at a value of spacing ratio (1.5 to 2).

Abstract: Fire-free forest conversion with organic inputs as an alternative to slash-and-burn could improve agro-ecosystem sustainability. We assessed soil carbon mass changes in a sandy-clayey and well-drained soil in French Guiana after forest clearing by the chop-and-mulch method and crop establishment. At the experimental site of Combi, native forest was cut down in October 2008; woody biomass was chopped and incorporated into the top 20cm of soil. After about one year of legume and grass cover, three forms of land management were compared: grassland (Urochloa ruziziensis), maize/soybean crop rotation with disk tillage and in direct seeding without tillage. There were four replicates. We measured 14.16kgm-2 of carbon in 2mm-sieved soil down to 2m depth for the initial forest. Forest clearing did not induce significant soil compaction; neither did any specific agricultural practice. In converted soils, C stocks were measured in the 0-30cm layer after each crop for three years. Carbon mass changes for soil fractions <2mm (soil C stock) and >2mm (soil C pool) in the 0-5, 5-10, 10-20 and 20-30cm soil layers were assessed on an equivalent soil mass basis. One year and 1.5 years after deforestation, higher C stocks (+0.64 to 1.16kgCm-2yr-1) and C pools (+0.52 to 0.90kgCm-2yr-1) were measured in converted soils, compared to those of the forest into the top 30cm of soil. However, the masses of carbon in these converted soils declined later. The highest rates of carbon decrease were measured between 1.5 and 2 years after forest conversion in the <2mm soil fraction, from 0.46kgCm-2yr-1 (in grassland soils) to 0.71kgCm-2yr-1 (in cropland under no tillage). The carbon pool declined during the third year at rates of 0.41kgCm-2yr-1 (cropland under disk tillage) to 0.76kgCm-2yr-1 (grassland soils). Three years after forest conversion, C masses in the top 30cm of soils for grassland showed similar values than for forest. In comparison, the carbon stock in cropped soils managed under no tillage in direct seeding (without mulch) was significantly 17% and 16% lower than in forest and grassland soils, respectively. None of the studied agricultural practices succeeded in accumulating carbon from the chopped forest biomass. © 2013 Elsevier B.V.

Abstract: Context: Tree orientation is controlled by asymmetric mechanical stresses set during wood maturation. The magnitude of maturation stress differs between longitudinal and tangential directions, and between normal and tension woods. Aims: We aimed at evaluating patterns of maturation stress on eucalypt plantation trees and their relation with growth, with a focus on tangential stress evaluation. Methods: Released maturation strains along longitudinal and tangential directions were measured around the circumference of 29 Eucalyptus nitens trees, including both straight and leaning trees. Results: Most trees produced asymmetric patterns of longitudinal maturation strain, but more than half of the maturation strain variability occurred between trees. Many trees produced high longitudinal tensile stress all around their circumference. High longitudinal tensile stress was not systematically associated with the presence of gelatinous layer. The average magnitude of released longitudinal maturation strain was found negatively correlated to the growth rate. A methodology is proposed to ensure reliable evaluation of released maturation strain in both longitudinal and tangential directions. Tangential strain evaluated with this method was lower than previously reported. Conclusion: The stress was always tensile along the longitudinal direction and compressive along the tangential direction, and their respective magnitude was positively correlated. This correlation does not result from a Poisson effect but may be related to the mechanism of maturation stress generation. © 2013 # The Author(s) 2013. This article is published with open access at Springerlink.com.

Abstract: The interlocking leaves of tank-forming bromeliads (Bromeliaceae) collect rainwater and detritus, thus creating a freshwater habitat for specialized organisms. Their abundance and the possibility of quantifying communities with accuracy give us unparalleled insight into how changes in local to regional environments influence community diversity in small water bodies. We sampled 365 bromeliads (365 invertebrate communities) along a southeastern to northwestern range in French Guiana. Geographic locality determined the species pool for bromeliad invertebrates, and local environments determined the abundance patterns through the selection of traits that are best adapted to the bromeliad habitats. Patterns in community structure mostly emerged from patterns of predator species occurrence and abundance across local-regional environments, while the set of detritivores remained constant. Water volume had a strong positive correlation with invertebrate diversity, making it a biologically relevant measure of the pools' carrying capacity. The significant effects of incoming detritus and incident light show that changes in local environments (e.g., the conversion of forest to cropping systems) strongly influence freshwater communities. Because changes in local environments do not affect detritivores and predators equally, one may expect functional shifts as sets of invertebrates with particular traits are replaced or complemented by other sets with different traits. © 2013 Springer Science+Business Media Dordrecht.