Abstract: Tree buckling risk (actual height/critical buckling height) is an important biomechanical trait of plant growth strategies, and one that contributes to species coexistence. To estimate the diversity of this trait among wide samples, a method that minimizes damage to the plants is necessary. On the basis of the rarely used, complete version of Greenhill's model (1881, Proceedings of the Cambridge Philosophical Society 4(2): 65-73), we precisely measured all the necessary parameters on a sample of 236 saplings of 16 species. Then, using sensitivity (variance) analysis, regressions between successive models for risk factors and species ranks and the use of these models on samples of self- and nonself-supporting saplings, we tested different degrees of simplification up to the most simple and widely used formula that assumes that the tree is a cylindrical homogeneous pole. The size factor had the greatest effect on buckling risk, followed by the form factor and the modulus of elasticity of the wood. Therefore, estimates of buckling risk must consider not only the wood properties but especially the form factor. Finally, we proposed a simple but accurate method of assessing tree buckling risk that is applicable to a wide range of samples and that requires mostly nondestructive measurements.

Abstract: The different hypotheses about buttress function and formation mainly involve mechanical theory. Forces were applied to two trees of Sloanea spp.. a tropical genus that develops typical thin buttresses. and the three-dimensional strains were measured at different parts of the trunk base. Risks of failure were greater on the buttress sides, where shear and tangential stresses are greater, not on the ridges. in spite of high longitudinal (parallel to the grain) stresses. A simple beam model, computed from the second moment of area of digitized cross sections, is consistent with longitudinal strain variations but cannot predict accurately variations with height. Patterns of longitudinal strain variation along ridges are very different in the two individuals, owing to a pronounced lateral curvature in one specimen. The constant stress hypothesis is discussed based on these results. Without chronological data during the development of the tree. it cannot be proved that buttress formation is activated by stress or strain.

Abstract: Premise of the study : Wood density correlates with mechanical and physiological strategies of trees and is important for estimating global carbon stocks. Nonetheless, the relationship between branch and trunk xylem density has been poorly explored in neotropical trees. Here, we examine this relationship in trees from French Guiana and its variation among different families and sites, to improve the understanding of wood density in neotropical forests. Methods : Trunk and branch xylem densities were measured for 1909 trees in seven sites across French Guiana. A major-axis fit was performed to explore their general allometric relationship and its variation among different families and sites. Key results : Trunk xylem and branch xylem densities were significantly positively correlated, and their relationship explained 47% of the total variance. Trunk xylem was on average 9% denser than branch xylem. Family-level differences and interactions between family and site accounted for more than 40% of the total variance, whereas differences among sites explained little variation. Conclusions : Variation in xylem density within individual trees can be substantial, and the relationship between branch xylem and trunk xylem densities varies considerably among families and sites. As such, whole-tree biomass estimates based on non-destructive branch sampling should correct for both taxonomic and environmental factors. Furthermore, detailed estimates of the vertical distribution of wood density within individual trees are needed to determine the extent to which relying solely upon measures of trunk wood density may cause carbon stocks in tropical forests to be overestimated.

Abstract: Outcrossing rates, pollen dispersal and male mating success were assessed in Dicorynia guianensis Amshoff, a neotropical tree endemic to the Guiana shield. All adult trees within a continuous area of 40 ha (n = 157) were mapped, and were genotyped with six microsatellite loci. In addition, progenies were genotyped from 22 mature trees. At the population level, the species was mostly outcrossing (t(m) = 0.89) but there was marked variation among individuals. One tree exhibited mixed mating, confirming earlier results obtained with isozymes that D. guianensis can tolerate selfing. A Bayesian extension of the fractional paternity method was used for paternity analysis, and was compared with the neighbourhood method used widely for forest trees. Both methods indicated that pollen dispersal was only weakly related to distance between trees within the study area, and that the majority (62%) of pollen came from outside the study stand. Using maximum likelihood, male potential population size was estimated to be 1119, corresponding to a neighbourhood size of 560 hectares. Male mating success was, however, related to the diameter of the stem and to flowering intensity assessed visually. The mating behaviour of D. guianensis is a combination of long-distance pollen flow and occasional selfing. The species can still reproduce when it is extremely rare, either by selfing or by dispersing pollen at long distances. These results, together with the observation that male mating success was correlated with the size of the trees, could be implemented in management procedures aiming at regenerating the species.