Almeras, T., Yoshida, M., & Okuyama, T. (2006). The generation of longitudinal maturation stress in wood is not dependent on diurnal changes in diameter of trunk. J. Wood Sci., 52(5), 452–455.
Abstract: A hypothetical mechanism for the generation of maturation stress in wood was tested experimentally. The hypothesis was that the maturation stress could partly originate in a physical mechanism related to daily changes in water pressure and associated diurnal strains. The matrix of lignin and hemicellulose, deposited in the cell wall during the night, would be put in compression by the effect of water tension during the next day. The cellulose framework, crystallizing during the day, would be put in tension by the decrease in tension at night and subsequent cell-wall swelling. This was tested on young saplings of sugi and beech. Half of the saplings were submitted to continuous lighting, which canceled diurnal strains. Saplings were tilted 40 degrees, and their uprighting movement was measured. The uprighting movement is directly due to the production of reaction wood and the concomitant development of large longitudinal maturation stress. It occurred in the continuously lighted plants at least as much as in control plants. We conclude that the generation of longitudinal maturation stress in tension or compression wood is not directly related to variations in water pressure and diurnal strains.
Keywords: maturation stress; growth stress; cell-wall maturation; continuous lighting; diurnal strains
|
Clair, B., Ruelle, J., Beauchene, J., Prevost, M. F., & Fournier, M. (2006). Tension wood and opposite wood in 21 tropical rain forest species 1. Occurrence and efficiency of the G-layer. IAWA J., 27(3), 329–338.
Abstract: Wood samples were taken from the upper and lower sides of 21 naturally tilted trees from 18 families of angiosperms in the tropical rain forest in French Guyana. The measurement of growth stresses ensured that the two samples were taken from wood tissues in a different mechanical state: highly tensile stressed wood on the upper side, called tension wood, and lower tensile stressed wood on the lower side, called opposite wood. Eight species had tension wood fibres with a distinct gelatinous layer (G-layer). The distribution of gelatinous fibres varied from species to species. One of the species, Casearia javitensis (Flacourtiaceae), showed a peculiar multilayered secondary wall in its reaction wood. Comparison between the stress level and the occurrence of the G-layer indicates that the G-layer is not a key factor in the production of high tensile stressed wood.
Keywords: gelatinous layer; G-layer; French Guyana; tropical rain forest; tension wood; wood anatomy
|
Clair, B., Almeras, T., & Sugiyama, J. (2006). Compression stress in opposite wood of angiosperms: observations in chestnut, mani and poplar. Ann. For. Sci., 63(5), 507–510.
Abstract: In order to face environmental constraints, trees are able to re-orient their axes by controlling the stress level in the newly formed wood layers. Angiosperms and gymnosperms evolved into two distinct mechanisms: the former produce a wood with large tension pre-stress on the upper side of the tilted axis, while the latter produce a wood with large compression pre-stress on the lower side. In both cases, the difference between this stress level and that of the opposite side, in light tension, generates the bending of the axis. However, light values of compression were sometimes measured in the opposite side of angiosperms. By analysing old data on chestnut and mani and new data on poplar, this study shows that these values were not measurement artefacts. This reveals that generating light compression stress in opposite wood contributes to improve the performance of the re-orientation mechanism.
Keywords: reaction wood; compression wood; tension wood; opposite wood; plant biomechanics; growth stresses; microfibrils angle
|
Scotti, I., Paglia, G., Magni, F., & Morgante, M. (2006). Population genetics of Norway spruce (Picea abies Karst.) at regional scale: sensitivity of different microsatellite motif classes in detecting differentiation. Ann. For. Sci., 63(5), 485–491.
Abstract: Four populations of Norway spruce (Picea abies Karst.) were screened using nine nuclear microsatellite markers (three trinucleotides and six dinucleotides) and four chloroplast markers (all mononucleotides). Marker classes were compared for their variability, mutation rate and ability to detect differentiation between stands. Dinucleotide markers proved to be the most variable group and chloroplast stretches the least variable, with differences in mutation rate between the former and the latter spanning over two orders of magnitude. Variability correlated to the number of repeats but not to the absolute length of the microsatellite region. The different marker classes were combined with two different measures of genetic distance in order to investigate the performance of markers and evolutionary models for the study of genetic variation in natural populations of Norway spruce. Weir and Cockeram's F-ST generally performed better in this clear-cut, four-population model study. Chloroplast haplotypes turned out to be the most sensitive marker system, being able to differentiate populations and to detect differences in genetic variability between sub-regions.
Keywords: conifers; SSR; divergence; statistical testing; genetic distance
|
Epron, D., Bosc, A., Bonal, D., & Freycon, V. (2006). Spatial variation of soil respiration across a topographic gradient in a tropical rain forest in French Guiana. J. Trop. Ecol., 22, 565–574.
Abstract: The objective of this study was to analyse the factors explaining spatial variation in soil respiration over topographic transects in a tropical rain forest of French Guiana. The soil of 30 plots along six transects was characterized. The appearance of the 'dry to the touch' character at a depth of less than 1.2 m was used to discriminate soils exhibiting vertical drainage from soils exhibiting superficial lateral drainage and along with colour and texture, to define five classes from well-drained to strongly hydromorphic soils. Spatial variation in soil respiration was closely related to topographic position and soil type. Increasing soil water content and bulk density and decreasing root biomass and soil carbon content explained most of the decrease in soil respiration from the plateaux (vertically drained hypoferralic acrisol) to the bottomlands (haplic gleysol). These results will help to stratify further field experiments and to identify the underlying determinants of spatial variation in soil respiration to develop mechanistic models of soil respiration.
Keywords: acrisol; carbon balance; carbon flux; gleysol; root biomass
|
Baraloto, C., Bonal, D., & Goldberg, D. E. (2006). Differential seedling growth response to soil resource availability among nine neotropical tree species. J. Trop. Ecol., 22, 487–497.
Abstract: Although the potential contribution to tropical tree species coexistence of niche differentiation along light gradients has received much attention, the degree to which species perform differentially along soil resource gradients remains unclear. To examine differential growth response to soil resources, we grew seedlings of nine tropical tree species at 6.0% of full sun for 12 mo in a factorial design of two soil types (clay and white sand), two phosphate fertilization treatments (control and addition of 100 mg P kg(-1)) and two watering treatments (field capacity and water limitation to one-third field capacity). Species differed markedly in biomass growth rate, but this hierarchy was almost completely conserved across all eight treatments. All species grew more slowly in sand than clay soils. and no species grew faster with phosphate additions. Only Eperua grandiflora and E. falcata showed significant growth increases in the absence of water limitation. Faster-growing species were characterized by high specific leaf area, high leaf allocation and high net assimilation rate but not lower root allocation. Slower-growing species exhibited greater plasticity in net assimilation rate. suggesting that tolerance of edaphic stress in these species is related more to stomatal control than to whole-plant carbon allocation. Although relative growth rate for biomass was correlated with both its physiological and morphological components. interspecific differences were best explained by differences in net assimilation rate across six of the eight treatments. A suite of traits including high assimilation and high specific leaf area maintains rapid growth rate of faster-growing species across a wide gradient of soil resources, but the lack of plasticity they exhibit may compromise their survival in the poorest soil environments.
Keywords: biomass allocation; Dicorynia; drought stress; Eperua; French Guiana; Goupia; Jacaranda; plasticity; Qualea; Recordorylon; relative growth rate; Sextonia; soil phosphorus; specific leaf area; Virola
|
Degen, B., Blanc, L., Caron, H., Maggia, L., Kremer, A., & Gourlet-Fleury, S. (2006). Impact of selective logging on genetic composition and demographic structure of four tropical tree species. Biol. Conserv., 131(3), 386–401.
Abstract: Over-exploitation and fragmentation are serious problems for tropical forests. Most sustainable forest management practices avoid clear-cuts and apply selective logging systems focused on a few commercial species. We applied a simulation model to estimate the impact of such selective logging scenarios on the genetic diversity and demography of four tropical tree species from French Guiana. The simulations used data on genetic and demographic composition, growth, phenology and pollen and seed dispersal obtained for Dicorynia guianensis, Sextonia rubra, Symphonia globulifera and Vouacapoua americana at the experimental site in Paracou. Whereas Symphonia globulifera serves as a model for a species with low logging pressure, the other three species represent the most exploited tree species in French Guiana. In simulations with moderate logging, typical for French Guiana, with large cutting diameter (> 60 cm diameter) and long cutting cycles (65 years), the two species V. americana and Sextonia rubra were not able to recover their initial stock at the end of the rotation period, with a large decrease in the number of individuals and in basal area. Under a more intensive logging system (cutting diameter > 45 cm diameter, cutting cycles of 30 years) that is common practice in the Brazilian Amazon, only Symphonia globulifera showed no negative impact. Generally, the differences between the genetic parameters in the control scenarios without logging and the logging scenarios were surprisingly small. The main reasons for this were the overlapping of generations and the effective dispersal ability of gene vectors in all species, which guarantee relative homogeneity of the genetic structure in different age classes. Nevertheless, decreasing the population size by logging reduced the number of genotypes and caused higher genetic distances between the original population and the population at the end of the logging cycles. Sensitivity analysis showed that genetic changes in the logging scenarios were principally determined by the growth, densities and cutting diameter of each species, and only to a very small extent by the reproductive system including factors such as pollen and seed dispersal and flowering phenology. (c) 2006 Elsevier Ltd. All rights reserved.
Keywords: demography; genetic diversity; logging; phenology; pollen and seed dispersal; simulation; trees; tropics
|
Clair, B., Almeras, T., Yamamoto, H., Okuyama, T., & Sugiyama, J. (2006). Mechanical behavior of cellulose microfibrils in tension wood, in relation with maturation stress generation. Biophys. J., 91(3), 1128–1135.
Abstract: A change in cellulose lattice spacing can be detected during the release of wood maturation stress by synchrotron x-ray diffraction experiment. The lattice strain was found to be the same order of magnitude as the macroscopic strain. The fiber repeat distance, 1.033 nm evaluated for tension wood after the release of maturation stress was equal to the conventional wood values, whereas the value before stress release was larger, corresponding to a fiber repeat of 1.035 nm, nearly equal to that of cotton and ramie. Interestingly, the fiber repeat varied from 1.033 nm for wood to 1.040 nm for algal cellulose, with an increasing order of lateral size of cellulose microfibrils so far reported. These lines of experiments demonstrate that, before the stress release, the cellulose was in a state of tension, which is, to our knowledge, the first experimental evidence supporting the assumption that tension is induced in cellulose microfibrils.
|
Maron, P. A., Schimann, H., Ranjard, L., Brothier, E., Domenach, A. M., Lensi, R., et al. (2006). Evaluation of quantitative and qualitative recovery of bacterial communities from different soil types by density gradient centrifugation. Eur. J. Soil Biol., 42(2), 65–73.
Abstract: Extracting and purifying a representative fraction of bacteria from soil is necessary for the application of many techniques of microbial ecology. Here the influence of different soil types on the quantitative and qualitative recovery of bacteria by soil grinding and Nycodenz density gradient centrifugation was investigated. Three soils presenting contrasted physicochemical characteristics were used for this study. For each soil, the total (AODC: acridine orange direct count) and culturable (cfa: colony-forming units) bacterial densities were measured in three distinct fractions: (i) the primary soil, (ii) the soil pellet (soil remaining after centrifugation), and (iii) the extracted cells. The automated-ribosomal intergenic spacer analysis (A-RISA) was used to characterize the community structure directly from the DNA extracted from each fraction. The physicochemical characteristics of soils were found to influence both the efficiency of bacterial cell recovery and the representativeness of the extracted cells in term of community structures between the different fractions. Surprisingly, the most representative extracted cells were obtained from the soil exhibiting the lowest efficiency of cell recovery. Our results demonstrated that quantitative and qualitative cell recovery using Nycodenz density gradient centrifugation are not necessarily related and could be differentially biased according to soil type. (c) 2006 Elsevier SAS. All rights reserved.
Keywords: bacterial community; soil; density gradient; DNA fingerprint
|
Almeras, T., Yoshida, M., & Okuyama, T. (2006). Strains inside xylem and inner bark of a stem submitted to a change in hydrostatic pressure. Trees-Struct. Funct., 20(4), 460–467.
Abstract: Tangential strains were measured with strain gauges at the surface of xylem and inner bark of saplings of Cryptomeria japonica D. Don. and Fagus silvatica L. during a pressurization test. The test consists in submitting the whole sapling to an artificially imposed hydrostatic pressure of increasing magnitude. The elastic response of the stems was found linear both at the surface of xylem and inner bark. A simple geometric model allows to compute radial strains in each tissue from tangential strain data. Inside inner bark, radial strains are much larger than tangential strains, because tangential strains are restrained by the core of wood. The material compliance of each tissue was computed as the ratio between the radial strain and the pressure that caused it. The material compliance of xylem is much lower than that of inner bark, but, as its thickness is much larger, its contribution to the apparent behavior of the stem is not negligible. Computation of material compliances by this pressurization test provides information about the specific behavior of each tissue in response to hydrostatic pressure. This can be used to estimate and interpret the calibration factor linking the water status of the plant to the apparent strain measured at its surface.
Keywords: diurnal strains; hydrostatic pressure; xylem; inner bark; mechanical properties
|
