Abstract: Over-exploitation and fragmentation are serious problems for tropical forests. Most sustainable forest management practices avoid clear-cuts and apply selective logging systems focused on a few commercial species. We applied a simulation model to estimate the impact of such selective logging scenarios on the genetic diversity and demography of four tropical tree species from French Guiana. The simulations used data on genetic and demographic composition, growth, phenology and pollen and seed dispersal obtained for Dicorynia guianensis, Sextonia rubra, Symphonia globulifera and Vouacapoua americana at the experimental site in Paracou. Whereas Symphonia globulifera serves as a model for a species with low logging pressure, the other three species represent the most exploited tree species in French Guiana. In simulations with moderate logging, typical for French Guiana, with large cutting diameter (> 60 cm diameter) and long cutting cycles (65 years), the two species V. americana and Sextonia rubra were not able to recover their initial stock at the end of the rotation period, with a large decrease in the number of individuals and in basal area. Under a more intensive logging system (cutting diameter > 45 cm diameter, cutting cycles of 30 years) that is common practice in the Brazilian Amazon, only Symphonia globulifera showed no negative impact. Generally, the differences between the genetic parameters in the control scenarios without logging and the logging scenarios were surprisingly small. The main reasons for this were the overlapping of generations and the effective dispersal ability of gene vectors in all species, which guarantee relative homogeneity of the genetic structure in different age classes. Nevertheless, decreasing the population size by logging reduced the number of genotypes and caused higher genetic distances between the original population and the population at the end of the logging cycles. Sensitivity analysis showed that genetic changes in the logging scenarios were principally determined by the growth, densities and cutting diameter of each species, and only to a very small extent by the reproductive system including factors such as pollen and seed dispersal and flowering phenology. (c) 2006 Elsevier Ltd. All rights reserved.

Abstract: Spontaneous gene flow between wild and cultivated chicory, Cichorium intybus L., may have implications for the genetic structure and evolution of populations and varieties. One aspect of this crop-wild gene flow is the dispersal of transgenes from genetically modified varieties, e.g. gene flow from GM chicory to natural chicory could have unwanted consequences. With the purpose to identify and quantify crop-wild gene flow in chicory, we analysed introgression in 19 wild chicory populations and 16 accessions of chicory varieties and landraces distributed across Northern, Central and Mediterranean Europe. The analysis used 281 AFLP markers and 75 SSAP markers giving a total of 356 polymorphic markers. Results from model based assignments with the program STRUCTURE indicated many incidents of recent gene flow. Gene flow was observed both between cultivars and wild populations, between landraces and wild populations, between different wild populations as well as between cultivars. Population structure visualized by distance-based clustering showed a North-South geographical structuring of the wild populations, and a general grouping of the cultivars corresponding to known origin. The results indicated, however, that the structuring between the two groups of wild and cultivated types was weak. As crop and wild recipients are genetically close and genes are transferred between the two types rather frequently, focus on mitigating crop-wild gene flow should be increased, before transgenic varieties are cultivated openly.

Abstract: A change in cellulose lattice spacing can be detected during the release of wood maturation stress by synchrotron x-ray diffraction experiment. The lattice strain was found to be the same order of magnitude as the macroscopic strain. The fiber repeat distance, 1.033 nm evaluated for tension wood after the release of maturation stress was equal to the conventional wood values, whereas the value before stress release was larger, corresponding to a fiber repeat of 1.035 nm, nearly equal to that of cotton and ramie. Interestingly, the fiber repeat varied from 1.033 nm for wood to 1.040 nm for algal cellulose, with an increasing order of lateral size of cellulose microfibrils so far reported. These lines of experiments demonstrate that, before the stress release, the cellulose was in a state of tension, which is, to our knowledge, the first experimental evidence supporting the assumption that tension is induced in cellulose microfibrils.

Abstract: A generalisation of existing mechanical models is proposed to account for the relation between wood macroscopic properties and fibre microstructure and chemical composition. It is applied to understanding of the origin of anisotropic maturation strains measured at the outermost surface of the xylem. Various assumptions are considered for boundary conditions of the fibre during the progressive maturation process and are applied to experimental data from the literature. Assumptions that the fibre is fully restrained in displacement, or fully unrestrained or unrestrained in the transverse direction only are all incompatible with observations. Indeed, within the tree, the fibre is restrained in the longitudinal and tangential directions, but unrestrained in the radial direction towards the bark. Mixed boundary conditions must be introduced to correctly simulate both longitudinal and tangential maturation strains. In the context of an analytical axisymmetric model, this is estimated by considering a parameter of partial release of tangential stress during maturation. Consistence with data and with finite element computation in the case of a square fibre confirmed that, because of the unrestrained radial condition, a large part of the tangential maturation stress is released in situ.

Abstract: A large number of sequence-specific SSRs were screened by using electrophoresis on metaphore agarose gels with the bands visualized by ethidium bromide staining. Many SSRs appeared as codominant and many as dominant markers, with presence or absence of bands. A simple Mendelian inheritance pattern for most codominant and dominant SSR loci was found. For many codominant SSR markers, null alleles were detected. The proportion of dominant microsatellites detected in this study (close to 50 %) was much higher than that commonly reported in many other studies. A high proportion of dominant markers together with a high frequency of codominant markers with null alleles may represent two important limitations for the use of microsatellites in different studies. On the other hand, many polymorphic codominant SSR microsatellite markers were found to be highly repeatable, and can be used for population studies, seed certification, quality control of controlled crosses, paternity analysis, pollen contamination, and mapping of QTL in related families. In this paper, we report on the inheritance pattern and diversity of codominant and dominant SSR microsatellites in seven families of Picea abies sharing a common mother.