Abstract: The mechanism for tree orientation in angiosperms is based on the production of high tensile stress on the upper side of the inclined axis. In many species, the stress level is strongly related to the presence of a peculiar layer, called the G-layer, in the fibre cell wall. The structure of the G-layer has recently been described as a hydrogel thanks to N-2 adsorption-desorption isotherms of supercritically dried samples showing a high mesoporosity (pores size from 2-50 nm). This led us to revisit the concept of the G-layer that had been, until now, only described from anatomical observation. Adsorption isotherms of both normal wood and tension wood have been measured on six tropical species. Measurements show that mesoporosity is high in tension wood with a typical thick G-layer while it is much less with a thinner G-layer, sometimes no more than normal wood. The mesoporosity of tension wood species without a G-layer is as low as in normal wood. Not depending on the amount of pores, the pore size distribution is always centred around 6-12 nm. These results suggest that, among species producing fibres with a G-layer, large structural differences of the G-layer exist between species.

Abstract: Cyclocephala colasi beetles are facultative endotherms that spend most of their adult lives inside the inflorescences of Philodendron solimoesense, where ambient temperature (T-a) averages about 28 degrees C due to floral thermogenesis. Measurements of respiration within a range of T-a showed that active beetles became spontaneously endothermic at T-a below 28 degrees C but were rarely endothermic above it. There was no evidence of endothermy within the inflorescences, indicating that activities in the floral chamber can occur without the high energy expense of endothermy. Bouts of endothermy occurred at lower T-a in respirometer chambers mainly in the evening, when the insects normally fly from one inflorescence to another, and during the night, when they normally eat and mate within the inflorescence. Patterns of endothermy in individual episodes were studied in non-flying beetles with respirometry and infrared thermal imaging. Heat was generated in the thorax by oscillatory waves of respiration that were coupled with thoracic temperature (T-th) increases. Stationary beetles could regulate T-th at about 33 degrees C independently of T-a between 16 and 29 degrees C. At T-a=20 degrees C, this represents a 116-fold increase in metabolic rate over resting, ectothermic values. Endothermy was clearly a requirement for flight, and beetles departing inflorescences warmed to about 30 degrees C before take-off. During flight, T-th was dependent on T-a, decreasing from 37 to 28 degrees C at T-a of 37 to 20 degrees C, respectively. The lowest T-a at which flight could occur was about 20 degrees C. Thermal conductance of stationary, endothermic beetles increased at higher metabolic rates, probably because of increased ventilatory heat loss.

Abstract: P>1. As trees in a given cohort progress through ontogeny, many individuals die. This risk of mortality is unevenly distributed across species because of many processes such as habitat filtering, interspecific competition and negative density dependence. Here, we predict and test the patterns that such ecological processes should inscribe on both species and phylogenetic diversity as plants recruit from saplings to the canopy. 2. We compared species and phylogenetic diversity of sapling and tree communities at two sites in French Guiana. We surveyed 2084 adult trees in four 1-ha tree plots and 943 saplings in sixteen 16-m2 subplots nested within the tree plots. Species diversity was measured using Fisher's alpha (species richness) and Simpson's index (species evenness). Phylogenetic diversity was measured using Faith's phylogenetic diversity (phylogenetic richness) and Rao's quadratic entropy index (phylogenetic evenness). The phylogenetic diversity indices were inferred using four phylogenetic hypotheses: two based on rbcLa plastid DNA sequences obtained from the inventoried individuals with different branch lengths, a global phylogeny available from the Angiosperm Phylogeny Group, and a combination of both. 3. Taxonomic identification of the saplings was performed by combining morphological and DNA barcoding techniques using three plant DNA barcodes (psbA-trnH, rpoC1 and rbcLa). DNA barcoding enabled us to increase species assignment and to assign unidentified saplings to molecular operational taxonomic units. 4. Species richness was similar between saplings and trees, but in about half of our comparisons, species evenness was higher in trees than in saplings. This suggests that negative density dependence plays an important role during the sapling-to-tree transition. 5. Phylogenetic richness increased between saplings and trees in about half of the comparisons. Phylogenetic evenness increased significantly between saplings and trees in a few cases (4 out of 16) and only with the most resolved phylogeny. These results suggest that negative density dependence operates largely independently of the phylogenetic structure of communities. 6. Synthesis. By contrasting species richness and evenness across size classes, we suggest that negative density dependence drives shifts in composition during the sapling-to-tree transition. In addition, we found little evidence for a change in phylogenetic diversity across age classes, suggesting that the observed patterns are not phylogenetically constrained.

Abstract: 1. Plants often rely on external, mutualistic partners to survive and reproduce in resource-limited environments or for protection from enemies. Such interactions, including mycorrhizal symbioses and ant plant associations, are widespread and play an important role at the ecosystem and community levels. In ant-plant mutualisms, the plants may benefit from both the protection provided by the presence of ants and from the nutrients absorbed from insect debris. However, the role of third partners in plant nutrition, particularly ant-associated fungi, has never before been demonstrated. 2. We investigate this issue in the ant-plant Hirtella physophora. In this model system, Allomerus decemarticulatus ants are involved in two, highly specific interactions: first, with their host plant, and, secondly, with a fungus that they actively manipulate. Moreover, the ants combine both plant trichomes and fungal hyphae to make a trap to capture prey. 3. We empirically demonstrate the existence of a third type of interaction between the fungus and the plant through the use of both experimental enrichments with stable isotopes (N-15) and histological approaches. The fungus growing in the galleries plays a role in providing nutrients to the host plant, in addition to the structural role it plays for the ants. Fungus-facilitated nitrogen uptake occurs mainly in old domatia, where abundant hyphae are in close contact with the plant cells. Whether the fungi inside the domatia and those in the galleries are the same is still uncertain. 4. Synthesis. Together, our results show that a fungal partner in an ant-plant mutualism can benefit the plant by improving its nutrient uptake, and they demonstrate the existence of a true tripartite mutualism in this system. Our results add further evidence to the notion that interpretations of some ant plant symbioses as purely protective mutualisms have overlooked these nutritional aspects.

Abstract: A hyperelastic constitutive model is developed for textile composite reinforcement at large strain. A potential is proposed, which is the addition of two tension and one shear energies. The proposed potential is a function of the right Cauchy Green and structural tensor invariants whose choice corresponds to textile composite reinforcement mechanical behavior which exhibits weak elongations in the fiber directions and large angular variations in the fabric plane. The model is implemented in a Vumat user routine of ABAQUS/Explicit. Some elementary tests are performed in order to identify the model and verify its validity. It is then used to simulate the hemispherical punch forming of balanced and unbalanced fabrics. A correct agreement is obtained with experimental forming processes.